TLI34 Alarm Set + TLI34B Baracuda Station, 4+1

TLI34 Bite Alarm Set + TLI34B Receiver Baracuda, 4+1

The set includes four bite alarms and the corresponding receiver with a new design and new features. The case of the set has a new design, and the sensor housings as well as the receiver are made from a material that does not degrade over time. The new set features an upgraded wheel axle, crafted from stainless steel. Both the bite alarms and the receiver operate on 9V batteries. The bite alarms and receiver are sold in a semi-rigid polyester case lined inside with foam, providing protection against mechanical shocks and dirt.

Note: Images are for informational purposes only. Batteries are not included!

Bite Alarm Features:

• • On/off: install the battery to start, press the on/off button: it will beep twice with a flash on startup, and once prolonged on shutdown;
  • V-volume button: press once and it beeps once, the cascading LEDs increase by one level, making the volume louder. Initially starts at level 7;
  • T-tone button: press once and it beeps once, the cascading LEDs increase by one level, using a different tone (total 8 tones). Initially starts on tone 6;
  • S-sensitivity/night light button: press once and it beeps once, the cascading LEDs increase by one sensitivity level from the base, with 8 sensitivity levels total, initially starting at level 1. Pressing the S button for 2 seconds turns on the night light. Pressing it again for 2 seconds turns off the night light;
  • Cascading LEDs: LEDs cascade up and down depending on each action;
  • Signal LED/night light/low battery indicator (below 5V);
  • Universal mounting thread;
  • Operates on 9V battery.

Receiver Features:

• Power on/off: install the battery to start, the indicator LED lights once and emits 3 sounds; when the receiver is off, 8 sounds are heard;
• Volume adjustment: initially starts at level 7. Press + and the cascading LEDs increase by one position, with a total of 8 positions. Press – and the cascading LEDs decrease by one position, lowering the volume by one level for the 8 positions, the lowest being vibration mode;
• Indicator LED/low battery;
• Learning mode: press the + and - buttons at the same time, the red LED lights up with a sound signal. Activate the bite alarm marked red by turning its alert system, the receiver will beep twice confirming completion. Then press the + button for the blue, green, yellow, purple, and white colors, following the same procedure until finished;
• LED diode for standby light;
• Low battery alarm (below 5V);
• Operates on 9V battery.