Carp Expert Piave 3+1 Bite Alarm Set

Carp Expert Piave 3+1 Bite Alarm Set

Getting started:

Receiver: Insert 3 x 1.5V AAA batteries as shown on the device. Battery insertion is easier after removing the hanger by moving the plastic tab located inside and on the top, then pushing the hanger upwards. The alarm LEDs are: red, yellow and green.

Alarm: Insert 1 x 9V battery into the device.

The receiver and alarms have a range of 150 metri and are rain-resistant.

Powering on and pairing:

The transmitter and receiver can be turned on separately by holding the power button for 3 seconds. A tone indicates the device is ready for use. After activation the transmitters connect automatically to the receiver. If this does not happen, you can pair the units as follows:

• 1. On the receiver press and hold the "A" and "T" buttons simultaneously.
• 2. Meanwhile, move the alarm's dial, mimicking a bite.
• 3. The receiver is ready for use.

The units can be turned off by pressing and holding the power button for 3 seconds.

Buttons:

Power on/off button.

• "V" Volume control button, 5 adjustment levels.
• "S" Sensitivity adjustment button, 5 levels. (To adjust the vibration function on the receiver)
• "T" Tone selection button, 5 adjustment levels.

   

Bite indication:

A bite is signalled both audibly and visually. After the bite stops both the receiver LED and the alarm LED flash for 20 seconds. During a bite the alarm sound increases or decreases directly proportional to the speed of the bite. The receiver signals a bite with a continuous beep. Both the station and the alarms feature a "Mute" function. The station can also signal a bite by vibration with the sound on "Mute".

Additional feature:

Two threaded metal pins can be inserted into the alarm to prevent the rod from detaching from the alarm during a bite. The bottom is fitted with a standard outlet for electric swingers. Thanks to the standard thread it can be mounted on all supports and rod pods.