Carp Expert Tevere 4+1 Bite Alarm Set

Carp Expert Tevere Bite Alarm Set 4+1

Operation:

Receiver: Insert 3 AAA 1.5V batteries as shown on the device. Battery installation is easier after removing the hanger by moving the plastic clip located inside and on the top, then pushing the hanger upwards. Two metal rods can be screwed into the alarm to prevent the rod from detaching during a bite. At the bottom, the alarm has a special slot for connecting swinger or hanger sockets.

Alarm: Insert a 9V battery into the device.

Powering on and pairing:

The alarm and the station can be turned on separately by pressing and holding a button for 3 seconds. A ready-to-use status is indicated by a sound. After activation, the alarms automatically connect to the station. If this does not happen, pairing can be done as follows:

• 1. On the station, simultaneously press and hold the "V" and "T" buttons.
• 2. Meanwhile, rotate the alarm knob, simulating a bite.
• 3. The station is ready to use.

The station and alarms can be turned off by pressing and holding the power button for 3 seconds.

Buttons:

Power on/off button.

• "V" Volume control button, 5 levels of adjustment.
• "S" Sensitivity adjustment button, 5 levels of adjustment. (To adjust the vibration function on the receiver)
• "T" Tone selection button, 5 levels of adjustment.

Bite indication:

A bite is signaled both audibly and visually. After the bite stops, both the station's and the alarm’s LEDs flash for 20 seconds. During a bite, the alarm’s sound intensifies or decreases proportionally with the bite speed. The station signals the bite with a continuous beep. LEDs are available in four colors: red, green, blue, and yellow.

NOTE: The station and alarms have a range of 150 meters, and the casing is rainwater resistant.